Map Settings - Alpine INE-W960A Owner's Manual

Route Planning Method types:
Button

5.3.5 Map settings

You can fine-tune the appearance of the Map screen. Adjust the map view to your needs,
choose suitable colour themes from the list for both daytime and night use, change the blue
arrow to a 3D car model, show or hide 3D buildings (optional), turn track logging on or off, and
manage you Place visibility sets (which Places to show on the map).
The map is always shown on the screen so that you can see the effect when you change a
setting.
Button
Gives a quick route if you can travel at or near the speed limit on all
roads. Usually the best selection for fast and normal cars.
Gives a short route to minimise the distance to travel. It can be
practical for slow vehicles. Searching for a short route regardless of
the speed, this route type is rarely practical for normal vehicles.
Gives a quick but fuel efficient route based on the fuel consumption
data given in Route settings (page 75). Travel cost and CO
calculations are estimations only. They cannot take elevations, curves
and traffic conditions into account.
Results in a route with fewer turns and no difficult manoeuvres. With
this option, you can make your software to take, for example, the
motorway instead of a series of smaller roads or streets.
Switch the map view between a 3D perspective view and two 2D top-
down view modes.
Adjust the basic zoom and tilt levels to your needs. Three preset levels
are available. There is also a manual mode when you can set the
zoom and tilt levels with the buttons on the left.
When selected, the map zooms out to show an overview of the
surrounding area if the next route event (manoeuvre) is far. When you
get close to the event, the normal map view returns.
Description
Description
78
emission
2