Epson SureColor F-Series Network Manual page 16

1. Click Start, highlight Control Panel, and then click Network and Internet
Connections. Select Network Connections.
2. Under LAN or High-Speed Internet, click the Local Area Connection icon.
3. Under Network Tasks, click Change settings of this connection.
4. Check if the following necessary components are in the list.
The following table lists the components required for configuring the network interface
with EpsonNet Config.
EpsonNet Config's setting screens
TCP/IP, WSD, UPnP, Bonjour
The following table lists the components required for network printing.
Printing method
TCP/IP printing
5. Double-click Internet Protocol (TCP/IP) on the Local Area Connection Properties
dialog box to open the Internet Protocols (TCP/IP) Properties dialog box. Set the IP
address, the subnet mask, etc. and then click OK.
6. Restart the computer.
The necessary components are now installed. Go to the section "Setting Up the Network
Interface" on page 18.
Necessary components
Internet Protocol (TCP/IP)
Necessary components
Internet Protocol (TCP/IP)
16
How To