Timing Of Replacing The Lamp - BenQ PX9210 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to
replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
Go to http://www.benq.com
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too
hot. Turn the projector off and let the projector cool for 45 minutes. If the lamp or Temp
indicator still lights up after turning the power back on, please contact your dealer. See
"Indicators" on page 68
The following lamp warning displays will remind you to change the lamp.
The warning messages below are for reference only. Please follow the actual on-screen
instructions to prepare and replace the lamp.
Status
Install a new lamp for optimal performance. If
the projector is normally run with Economic
selected (See
on page 62), you may continue to operate the
projector until the next lamp warning appears.
Press ENTER to dismiss the message.
It is strongly recommended that you replace the
lamp at this age. The lamp is a consumable item.
The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level
has significantly diminished.
Press ENTER to dismiss the message.
The lamp MUST be replaced before the
projector will operate normally.
Press ENTER to dismiss the message.
Maintenance
for a replacement lamp.
for details.
"Setting Lamp mode as Economic"
Message
63