About this Manual
Aim of the Manual
This manual aims to provide all the information necessary for the development, design, and
installment of POS systems, order entry systems, and other receipt issuing systems that use TM-
T88V-i.
TM-T88V-i provides different available functions depending on the product specification and TM-i
Firmware version.
Refer to an appropriate Technical Reference Guide described in the following table.
TM-T88V-i product
*1
specification
TM-T88V-i
(with a Serial port)
TM-T88V-i
(without a Serial port)
*1: You can check the rear of the printer for the availability of serial ports.
TM-T88V-i (without a Serial port)
15 pin connector (Female)
(Blue)
*2: Print a status sheet to confirm the version of TM-i Firmware. Make sure that this product is ready
to print (the paper is set and the power is turned on), and hold down the push button at the rear of
this product for at least 3 seconds before releasing it.
(See
"Confirming with a status sheet" on page
TM-i Firmware Ver.3.x or earlier
<General Information>
Software
X.XX
Model
TM-T88V-i
"Software" (TM-i Firmware Version) is printed
under <General Information>.
6
*2
TM-i Firmware Version
Ver.4.0 or later
Ver.4.0 or later
Ver.3.x or earlier
54.)
Technical Reference Guide to be used
TM-T88V-i (TM-i Firmware Ver.4.0 or later)
Technical Reference Guide
TM-T88V-i (TM-i Firmware Ver.4.0 or later)
Technical Reference Guide
TM-T88V-i (TM-i Firmware Ver.3.x or earlier)
Technical Reference Guide (This document)
TM-T88V-i (with a Serial port)
9 pin connector (Male)
TM-i Firmware Ver.4.0 or later
<General Information>
Firmware
X.XX
ePOS-Device
X.XX
"Firmware" (TM-i Firmware Version) is printed
under <General Information>.