Epson TM-T88V-i Technical Reference Manual page 51

Optional Buzzer
When to sound the buzzer is selectable from the following occasions.
• When an error occurs
• When automatic paper cut activates
• When specified pulse 1 (2 pin) occurs
• When specified pulse 2 (5 pin) occurs
Setting the number of head energizing parts
• One-part energizing (initial setting)
• Two-part energizing
• Four-part energizing
 Usually, the number of head energizing parts does not need to be changed.
 The maximum print speed can be performed only when one-part energizing is selected.
Setting the power supply unit capacity
Selectable from levels 1 to 3 (Low  High) (initial setting: level 3)
When a problem such as a low voltage error and power shutdown occurs due to the print pattern or
the power supply environment, you might work around the problem by setting the power supply
unit capacity.
If you cannot solve the problem by setting the power supply unit capacity to "level 1", you can try
reducing the print speed, increasing the number of head energizing parts, or revising the print
pattern (reducing the print volume).
Setting the automatic paper cut
• Not use this function (initial setting)
• Cut paper when the cover is closed
• Print logo when paper is cut
"Printing logo when paper is cut" is not available with software setting mode.
Setting the paper reduction
• Extra upper space reduction: enabled or disabled (initial setting)
• Extra lower space reduction: enabled or disabled (initial setting)
• Line space reduction rate: not reduced (initial setting), 25%, 50%, or 75%
• Line feed reduction rate: not reduced (initial setting), 25%, 50%, or 75%
• Barcode height reduction rate: not reduced (initial setting), 25%, 50%, or 75%
Chapter 2 Setup
2
51