Lamp - Chauvet Followspot 1200 Quick Start Manual

Setup

Lamp

Lamp
Removal
Opening the
Fixture
Lamp Removing
Diagram
Removing an
Existing Lamp
6
The user may have to install the lamp before operating the Followspot 1200
for the first time.
The instructions below include the steps to remove an existing lamp as well
as to install a new lamp.
Removing an already installed lamp requires caution. Follow the steps
indicated below to complete the removal in a safe manner.
Make sure that there is no power applied to the fixture before opening
the fixture's housing.
Lamp explosion hazard! Wait 15 minutes after having turned off the
fixture to open the lamp cover.
1) Unfasten the thumbscrew (T) and slide the front cover (FC) slightly
forward.
2) Loosen the thumbscrew that hold the lamp cover (LC) and lift it to expose
the lamp socket.
L
FC
T
• Always wear safety goggles and soft gloves when handling the
lamp.
• The bulb remains hot for a long time after turn off.
• Never touch the bulb barehanded and always handle it by its
metallic contacts.
1) Once you have access to the lamp, loosen both lamp end screws.
2) Grab the lamp by both lamp end screws, push it evenly against the clips
and then slide it upwards until it is free.
3) Place the lamp in an appropriate container for disposal.
Always follow local regulations regarding the disposal of used metal
halide lamps.
Followspot 1200 Quick Start Guide Rev. 3
LC