Specifications - Sony SHAKE-X7D Operating Instructions Manual


The radio waves broadcast by this
system may interfere with the operation
of some medical devices. Since this
interference may result in malfunction,
always turn off the power on this system
and BLUETOOTH device in the following
locations:
 In hospitals, on trains, in airplanes, at
gas stations, and any place where
flammable gases may be present.
 Near automatic doors or fire alarms.

This system supports security functions
that comply with the BLUETOOTH
specification to ensure security
connection during communication
using BLUETOOTH technology.
However, this security may be
insufficient depending on the setting
contents and other factors, so always be
careful when performing
communication using BLUETOOTH
technology.

Sony cannot be held liable in any way for
damages or other loss resulting from
information leaks during
communication using BLUETOOTH
technology.

BLUETOOTH communication is not
necessarily guaranteed with all
BLUETOOTH devices that have the same
profile as this system.

BLUETOOTH devices connected with this
system must comply with the
BLUETOOTH specification prescribed by
the Bluetooth SIG, Inc., and must be
certified to comply. However, even
when a device complies with the
BLUETOOTH specification, there may be
cases where the characteristics or
specifications of the BLUETOOTH device
make it impossible to connect, or may
result in different control methods,
display or operation.

Noise may occur or the audio may cut off
depending on the BLUETOOTH device
connected with this system, the
communications environment, or
surrounding conditions.

Specifications

Amplifier section
The following are measured at
AC 120 V – 240 V, 50/60 Hz
SHAKE-X7D
Power Output (rated):
800 W + 800 W (at 8 ohms, 100 Hz,
1% THD)
RMS output power (reference):
1200 W + 1200 W (per channel at
8 ohms, 100 Hz)
SHAKE-X3D
Power Output (rated):
400 W + 400 W (at 4 ohms, 100 Hz,
1% THD)
RMS output power (reference):
600 W + 600 W (per channel at
4 ohms, 100 Hz)
Inputs
AUDIO IN 1/PARTY CHAIN IN L/R
Voltage 2 V, impedance 47 kilohms
AUDIO IN 2 L/R
Voltage 2 V, impedance 47 kilohms
MIC 1, MIC 2
Sensitivity 1 mV, impedance
10 kilohms
(USB) 1, (USB) 2 port: Type A
Outputs
AUDIO OUT/PARTY CHAIN OUT L/R
Voltage 2 V, impedance 1 kilohm
VIDEO OUT
Max. output level 1 Vp-p,
unbalanced, Sync. negative load
impedance 75 ohms
USB section
Supported bit rate
WMA: 48 kbps – 192 kbps, VBR, CBR
AAC: 48 kbps – 320 kbps, VBR, CBR
Sampling frequencies
WMA: 44.1 kHz
AAC: 44.1 kHz
Supported USB device
Mass Storage Class
Maximum current
1 A
55 GB