Belkin Wireless G+ User Manual page 49

Using the Web-Based Advanced User Interface Using the Web-Based Advanced User Interface
G Plus Mode*
The Router supports two high-speed modes, 125 G Plus mode and
Frame-Bursting mode.
Selecting "125 G Plus mode" will result in all devices running in 125
G Plus mode if all devices are capable of 125Mbps speeds. If any
non-125 G Plus devices connect or associates with the network,
the Router will automatically shift the entire network back to Frame-
Bursting mode.
Selecting "Frame Bursting" will result in all devices capable of
Frame-Bursting to function in Frame-Bursting mode, and all clients
not capable, to operate in normal 802.11g modes. Frame-Bursting
mode supports both Frame-Bursting-enabled devices and non-Frame-
Bursting-enabled devices simultaneously. Frame-Bursting mode is
based on the unreleased 802.11e specification.
Selecting "Off" will disable Turbo mode.
*When operating in 125 G Plus Mode, this Wi-Fi device achieves
an actual throughput of up to 34.1Mbps, which is the equivalent
throughput of a system following 802.11g protocol and operating at a
signaling rate of 125Mbps. Actual throughput will vary depending on
environmental, operational, and other factors.
46 46