Transmitter/Receiver Learn Routine - Python 750 Installation Manual

In order to enter Learn Routine™ the Valet
sequence to remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1.
2.
3.
NOTE: When programming a transmitter button to step three, the assigned button will provide an
instant output on the red/white wire.
Once you have selected the step, press the button once more and hold it. The unit will chirp one, two
or three times depending on the channel selected. Do not release the momentary button.
4.
5.
You can step from one step to another by releasing the Valet
and then holding it. For instance: You have programmed channel one and you want to program channel two.
®
Release the Valet /program button. Press it one time and release it to advance from step one to step two. Now,
press and hold the button down and the unit will chirp twice. As before, do not release it.
If you want to program channel two (instant) after programming channel one, release the momentary button press it
twice and release it to advance to step three. Then press it once more and hold it. The siren will chirp three times to
confirm it is ready to receive the code from the transmitter.
Learn Routine™ will be exited if:
• Ignition is turned off
• Door is closed
• Program button is pressed too many times
• More than 15 seconds elapses between steps
One long chirp indicates that Learn Routine
© 1995,1997 Directed Electronics, Inc. Vista, CA

TRANSMITTER/RECEIVER LEARN ROUTINE™

® /Program button must be plugged into the blue port. There is a basic
Door
Open a door. Either the H1/5 GREEN or the H1/7 VIOLET door
trigger wire must be connected for the control unit to "see" an
open door.
Key
Turn the ignition on to the run position. The H1/9 YELLOW
switched ignition input must be connected.
Choose
Within 15 seconds, press and release the momentary button
to select the channel you wish to program:
Press and Release
One time
Two times
Three times
Transmit
While holding the momentary button, press the button on the transmitter that
you would like to control the selected receiver channel. One chirp will confirm
that the code has been learned.
Release
Once the code is learned, the button can be released.
™
has been exited
To Program
Arm/disarm/panic
Channel two output
(Silent Mode ™ /Remote Valet
Channel three output
® /program button and tapping it to advance steps
16
® )
97N437.597