Electro-Hydraulic Stand; Activation Conditions - PIAGGIO X9 Evolution 500 User Manual

Electro-hydraulic stand

Correct operation of the electric stand is ensured by a control system which automat-
ically checks the system operating conditions. Read the warnings below to avoid any
faults that may be caused from incorrect use.
The electro-hydraulic central stand can be used like the traditionnal one (press on the
with the feet and contemporarily raise back the vehicle acting on the side-grips)

Activation conditions (02_12, 02_13)

Check the stableness and slope of the ground. pay particular attention when parking
the vehicle on uneven ground and on streets with grades over 10%, in the latter sit-
uation park the vehicle with the front part facing uphill. This is both for safety reasons
and to make it easier to use the stand.
Straddle the vehicle and keeping it perpendicular to the ground, continuously press
button «I» to activate the electro-hydraulic stand.
Once finished a buzzer indicates that the vehicle is completely parked on its stand.
The electric stand can only be activated with the VEHICLE STOPPED ENGINE ON.
The device ONLY LIFTS THE VEHICLE.
02_12
To avoid running the battery down, after EACH COMPLETE ACTIVATION of the
stand it is necessary to wait 60 SECONDS before another activation. During these 60
seconds a buzzer will sound each time the button is pressed, indicating that you must
wait.
N.B.
IF THE BUTTON IS ACCIDENTALLY PUSHED WHILE RIDING (AT SPEEDS OVER
5 KM/H), THE STAND WILL NOT OPERATE AND THE BUZZER WILL GO OFF
WARNING THAT YOU ARE ATTEMPTING TO DO SOMETHING THAT IS NOT
CORRECT.
THIS SAFETY FUNCTION IS GUARANTEED BY CORRECT OPERATION OF THE
02_13
SPEEDOMETER. IF THE SPEEDOMETER DOES NOT WORK, YOU NEED TO GO
TO AN AUTHORIZED PIAGGIO SERVICE CENTER AS SOON AS POSSIBLE TO
HAVE IT REPAIRED.
CORRECT OPERATION OF THE ELECTRIC PART OF THE STAND IS CONTIN-
UOUSLY MONITORED BY THE RED LIGHT (ALARM) «L» ON THE INSTRUMENT
42