Using The Network Settings - Sony Ipela Application Manual

Device list: Displays devices for IPv6. After selecting
and setting a device to configure, the device list will
be updated automatically.
IPv6: Enables you to switch IPv6 modes.
Obtain IP address automatically: Sets DHCP mode to
on.
Use the following IP address: Sets DHCP mode to off.
When this is set, specify an IP address, prefix, default
gateway to specify the fixed address. You can also
add a check to "After getting response of ping, the IP
will be skipped" to determine whether the specified
IP address is already in use or not.
Obtain DNS server address automatically: Sets DNS
mode to on.
Use the following DNS server address: Sets DNS
mode to off. When this is set, specify a preference
DNS server address and alternative DNS server
address.
IPv6 Setting tab (when multiple devices are
selected from a device list)
You can configure network information (IPv6) for
multiple devices selected from the Device list.
Based on the multiple devices selected, the following
points are different from the Basic Setting tab when a
single device is selected.
Use the following IP address: Sets the DHCP mode off,
then specifying the start and end IP addresses
enables you to configure sequential IP addresses.
Network address: Displayed when multiple devices are
selected from a device list and when multiple
network addresses exist. Selecting the network
address where the device you want to configure
exists enables you to configure collectively.

Using the Network settings

1
Select a device you want to assign an IP address to
from the list and click Network.
The account settings screen is displayed.
2
Register the name and password of the
administrator and click OK.
The factory settings for both items are "admin".
The Network Setting screen is displayed.
3
Set the IP address.
To obtain the IP address automatically from a
DHCP server:
Select Obtain IP address automatically.
The IP address, Subnet mask and Default gateway
are assigned automatically.
Note
When you select Obtain IP address
automatically, make sure that the DHCP server is
operating on the network.
7
Using the SNC toolbox