Creating A Goto Route From The Cursor - Magellan eXplorist 100 Reference Manual

Routes
Creating a GOTO Route from the Plotter Cursor
This will create a GOTO route to a point on the plotter that you have indicated by moving the
crosshair cursor on the Plotter screen.
1. While viewing the Plotter screen, use the Arrow joystick, causing the eXplorist to go
into Cursor mode.
2. Continue using the Arrow joystick to move the crosshair cursor to a point on the
plotter that represents where you want to go.
3. Press GOTO.
4. If a GOTO is active, you will be asked to deactivate it and create a new GOTO route.
Highlight Yes and press ENTER to overwrite the existing GOTO. You are then
asked whether you want to create a new GOTO route. Highlight Yes and press
ENTER.
5. Confirm that you want to create a GOTO from the current
cursor position. Highlight Yes.
(If you highlight No and press ENTER, the eXplorist assumes
that you still want to create a GOTO, just not to the current
cursor position. The POI database screen will be displayed
so that you can search the database for the POI you want to
use as the destination.)
6. Press ENTER.
After you press ENTER, the last viewed navigation screen will be displayed, updated as
needed to provide information about the GOTO route you have created. On the Plotter
screen, a line will be drawn representing the GOTO route. The Compass screen will change
to display the name of the POI used as the destination in the screen header bar and an icon
representing the destination outside the compass diameter.
34
Attention
Goto
current
cursor
position?
Yes No
Creating a GOTO using the
cursor confirmation