Setting Security Restrictions; To Set The Security Level - Sony MSU-1000 Operation Manual

8
[Enter]
Press .
The cursor position is set, and the RPN Correction screen
changes to the following.
RPN Correction
Cursor Indication
H/V
H Cursor V Cursor
Cursor
9
Turn the adjustment knob on the far right to correct
the defect on the monitor.
Turning the adjustment knob right increases the
brightness level, and turning it left decreases the
brightness level. View the monitor and perform
adjustments until the defects are not visible.
RPN Correction
Cursor Indication
H/V
H Cursor V Cursor
Cursor
10
[Save]
Press .
The brightness correction value is registered to the control
panel.
To set a different correction value, press
the previous value, and repeat the procedure from step 9.
11
[Exit]
Press .
The brightness correction value is registered to the control
panel.
Engineer Mode Exit
Delete
Save Cancel
Level
99
Engineer Mode Exit
Delete
Save Cancel
Level
99
[Delete]
to delete

Setting Security Restrictions

To set the security level

You can restrict the control functions of the control panel if
necessary.
1
Enter engineer mode. (page 35)
Security
Page Item Code
Permission Permission Change
MSU ALL
Preset
2
Set the security level.
The settings for the security level are split into two
screens. Press each of the buttons to display each setting
screen and configure the security level settings.
[Page Permission]
When
Page Permission
Full View Custom
Lock Mode Paint Only
The following settings can be configured.
[Full Lock]
: Press this to light the button and prohibit all
operations of the control panel.
[View Mode]
: Press this to light the button and prohibit all
operations of the control panel except for viewing data.
[Custom Paint Only]
: Press this to light the button and
prohibit the majority of menu operations other than
custom paint menu operations.
[Item Permission]
When
Engineer Mode Exit
Engineer
Mode
is pressed:
Engineer Mode Exit
is pressed:
Engineer Mode
Settings
27