To Change Rcp Assignments - Sony MSU-1000 Operation Manual

To change RCP assignments

[RCP Assignment]
Selecting
to change RCP assignments.
Note
The following RCP assignment function is only available in
MCS mode. In addition, the function is not available when an
MSU-900/950 is set as the master.
To set RCP assignments
RCP Assignment
Files RCP List
Panel-01
1 2
Panel-02
Panel-03
Panel-04
3 4
Panel-05
Panel-06
Panel-07
5 CLR
Panel-08
Panel-09
Panel-10
Store Panel-11
Panel-12
Panel
1
Use the "Panel" knob to select the RCP number for
which you want to change assignment.
[All Camera]
If you select the
cameras will be displayed. (When
selected, only devices with established connections to the
Master of the MCS mode are displayed.)
2
Use the "Camera" knob to select the camera that will
be controlled from the RCP selected in step 1.
3
To return all RCP assignments to their standard state,
[All Reset]
press the button.
4
[Set]
Press the button.
The setting changes are applied.
You can save up to five states of RCP assignment to the MSU
internal memory, and retrieve them to reflect in the system, as
needed.
To retrieve the state of RCP assignment saved to the
MSU internal memory
1
Press the file number button to select the saved state
of RCP assignment you want to read.
The selected file button lights, then the state of RCP
assignment is reflected in the RCP List.
RCP Assignment
Files
RCP List
Panel-01
1 2
Panel-02
3 4
5 CLR
Store
Panel
Buttons to operate memory files stored in the unit
in the Config menu allows you
Exit
Camera-01
Set
Camera-02
Camera-03
Camera-04
Cancel
Camera-05
Camera-06
Camera-07
All
Camera-08
Camera
Camera-09
Camera-10
All
Camera-11
Reset
Camera -12
Camera
button, all RCPs and
[All Camera]
is not
Exit
Camera-01
Set
Camera-02
Cancel
All
Camera
All
Reset
Camera
Notes
• You can select only the file number button that has state
of RCP assignment saved.
• When the file number button is pressed and a changed
state is reflected in the RCP List, RCP assignment has
not yet been reflected in the system. You can add RCP
assignment changes by using the Panel knob and
Camera knob.
• If the panel existed when an RCP assignment file was
saved, but no longer exists when the file is read, the
assignment state of the non-existing panel is not
guaranteed.
2
[Set]
Press the button.
The file number button light goes off, and the change of
setting is confirmed.
To save the state of RCP assignment to the MSU
internal memory
1
Set the state of RCP assignment.
2
[Store]
Press the button.
[Store]
The button lights.
RCP Assignment
Files
RCP List
Panel-01
1 2
Panel-02
3 4
5 CLR
Store
Panel
3
Press the file number to save.
The state of RCP assignment is saved to the assigned file
[Store]
number, and the button and the file number button
lights go off.
To clear the RCP assignment file saved to the MSU
internal memory
1
Press the file number button to select the saved state
of RCP assignment you want to clear.
The selected file button lights, then the state of RCP
assignment is reflected in the RCP List.
RCP Assignment
Files
RCP List
Panel-01
1 2
Panel-02
3 4
5 CLR
Store
Panel
Exit
Camera-01
Set
Camera-02
Cancel
All
Camera
All
Reset
Camera
Exit
Camera-01
Set
Camera-02
Cancel
All
Camera
All
Reset
Camera
Menus
63