Monitor Out - BenQ TH682ST User Manual

Function
Standby
Settings
Reset All
Settings
Current
System
Status
44 Operation
Downloaded From projector-manual.com BenQ Manuals

Monitor Out

Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER 1 jack is
correctly connected to devices. See
to make the connection.
Audio Pass Through
Press / to choose the source that you wish to use in operation
mode. See "Connection" on page 15
When the corresponding jacks are correctly connected to the device,
the projector can output an audio signal to the external speaker when
it is in standby mode. The built-in speaker(s) will be muted in standby
mode.
Enabling this function slightly increases the standby power consumption.
Returns all settings to the factory preset values.
The following settings will still remain: Phase, H. Size, Projector
Installation, Color Space Conversion, High Altitude Mode, Security
Settings and Baud Rate.
Source
Shows the current signal source.
Picture Mode
Shows the selected mode in the PICTURE menu.
Lamp Mode
Shows the current lamp mode.
Resolution
Shows the native resolution of the input signal.
3D Format
Shows the current 3D mode.
Color System
Shows input system format.
Equivalent Lamp Hour
Displays the number of hours the lamp has been used.
Firmware Version
Shows the firmware version of your projector.
Description
"Connection" on page 15
for how to make the connection.
for how