Initialize Operation - Epson Stylus COLOR 1520 Service Manual

EPSON Stylus COLOR 1520

4.1.2 Initialize Operation

This operation is performed to write the factory values in the EEPROM on the MAIN board. With this
operation, the factory values are written in at a time.
1. Connect the printer and the host computer with a parallel interface cable.
2. Start the adjustment program in the host computer.
3. Select "CUSTOMER SET" in the 1 st menu and press the Enter key.
4. Move the cursor using
Enter key, and the main menu appears on the monitor.
5. Move the cursor using
the main menu appears on the monitor.
6. Move the cursor using
initialization. Then press the Enter key to return to the main menu.
7. Select other adjustment using
8. Move the cursor using
Note
1. Unless "CUSTOMER SET" is executed, the program does not proceed to the main menu.
2. Input of an incorrect customer code does not assure the proper operation of the program.


Adjusted values are not stored in the EEPROM until the printer is turned off. Therefore be sure to
turn off the printer once after the adjustment program is executed.


The set value is transferred to the printer when this operation is executed. Therefore do not turn
off the printer before executing " INITIALIZE" .
4-4
 
or key to select an appropriate customer code and area. Then press the
 
or key to select "ADJUST" in the 1st menu. Then press the Enter key, and
 
or key to select "INITIALIZE". Then press the Enter key to execute the
 
or key, or select RETURN TO 1st MENU to exit the main menu.
 
or key to select "END" and press the Enter key to exit the program.
WORK POINT
Rev. A