Ip Setup; Management Ip Addresses - ZyXEL Communications GS1920 series User Manual

Intelligent layer 2 gbe switch
Hide thumbs Also See for GS1920 series:
Table of Contents

Advertisement

Table 12 Basic Setting > Switch Setup (continued)
LABEL
Leave Timer
Leave All Timer
Priority Queue Assignment
IEEE 802.1p defines up to eight separate traffic types by inserting a tag into a MAC-layer frame that contains
bits to define class of service. Frames without an explicit priority tag are given the default priority of the
ingress port. Use the next fields to configure the priority level-to-physical queue mapping.
The Switch has eight physical queues that you can map to the 8 priority levels. On the Switch, traffic assigned
to higher index queues gets through faster while traffic in lower index queues is dropped if the network is
congested.
Priority Level (The following descriptions are based on the traffic types defined in the IEEE 802.1d standard
(which incorporates the 802.1p).
Level 7
Level 6
Level 5
Level 4
Level 3
Level 2
Level 1
Level 0
Apply
Cancel

8.6 IP Setup

Use the IP Setup screen to configure the Switch IP address, default gateway device, the default
domain name server and the management VLAN ID. The default gateway specifies the IP address of
the default gateway (next hop) for outgoing traffic.

8.6.1 Management IP Addresses

The Switch needs an IP address for it to be managed over the network. The factory default IP
address is 192.168.1.1. The subnet mask specifies the network number portion of an IP address.
The factory default subnet mask is 255.255.255.0.
You can configure up to 64 IP addresses which are used to access and manage the Switch from the
ports belonging to the pre-defined VLAN(s).
Chapter 8 Basic Setting
DESCRIPTION
Leave Time sets the duration of the Leave Period timer for GVRP in milliseconds. Each port
has a single Leave Period timer. Leave Time must be two times larger than Join Timer;
the default is 600 milliseconds.
Leave All Timer sets the duration of the Leave All Period timer for GVRP in milliseconds.
Each port has a single Leave All Period timer. Leave All Timer must be larger than Leave
Timer.
Typically used for network control traffic such as router configuration messages.
Typically used for voice traffic that is especially sensitive to jitter (jitter is the variations in
delay).
Typically used for video that consumes high bandwidth and is sensitive to jitter.
Typically used for controlled load, latency-sensitive traffic such as SNA (Systems Network
Architecture) transactions.
Typically used for "excellent effort" or better than best effort and would include important
business traffic that can tolerate some delay.
This is for "spare bandwidth".
This is typically used for non-critical "background" traffic such as bulk transfers that are
allowed but that should not affect other applications and users.
Typically used for best-effort traffic.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields.
GS1920 Series User's Guide
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents