Makita HM0810 Instruction Manual
  1. Manuals
  2. Brands
  3. Makita Manuals
  4. Power Tool
  5. HM0810
  6. Instruction manual

Makita HM0810 Instruction Manual

Hide thumbs Also See for HM0810:

Advertisement

Table of Contents

See also: Technical Information , Instruction Manual
Demolition Hammer
MODEL HM0810
MODEL HM0810B
I N S T R U C T I O N
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
DOUBLE
INSULATION
M A N U A L
004866
004954

Advertisement

Table of Contents
loading

Related Manuals for Makita HM0810

Summary of Contents for Makita HM0810

  • Page 1 Demolition Hammer MODEL HM0810 MODEL HM0810B 004866 004954 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

  • Page 2: Specifications

    The typical weighted root mean square acceleration Standard and can, therefore, also be used from sockets without earth wire. value is 9 m/s Yasuhiko Kanzaki CE 2003 Director MAKITA INTERNATIONAL EUROPE LTD. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND...

  • Page 3: Safety Instructions

    SAFETY INSTRUCTIONS ENA001-2 WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before operating this product and save these instructions. For safe operations: tion and changing accessories.
  • Page 4 ADDITIONAL SAFETY RULES FOR TOOL ENB009-1 Hold tools by insulated gripping surfaces when In cold weather or when the tool has not been performing an operation where the cutting tool used for a long time, let the tool warm up for a may contact hidden wiring or its own cord.

  • Page 5: Functional Description

    Installing or removing the bit 004870 For HM0810 Pivot the tool retainer to the side.(If it is difficult to move the tool retainer with your thumbs, tap it with a hammer.) Insert the bit into the tool barrel as far as it will go.

  • Page 6: Operation

    For HM0810B 002914 Clean the bit shank before installing the bit. Press in the tool retainer and turn it until the red dots on the tool retainer and the tool holder are aligned. Release the tool retainer. 1. Red dot (Tool holder) 2.
  • Page 7 Run the tool for several minutes to warm it up. Switch off and unplug the tool. Remove the crank cap using a Makita lock nut wrench 35 (optional accessory). Rest the tool on the table with the bit end pointing upwards. This will allow the old grease to collect inside the crank housing.
  • Page 8 CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
  • Page 9 Memo...
  • Page 10 Memo...
  • Page 11 Memo...
  • Page 12 Makita Corporation 883521I5...

This manual is also suitable for:

Hm0810b

Table of Contents