Advertisement
To Set Up Recording Rates
Right click to open the menu and select MAIN MENU, then select SETTINGS followed by CAMERA and
finally ENCODE.
In this menu you may set individual encoding options for Regular, Motion Detect and Alarm Recording.
While any of the cameras may be set higher, please be aware that it will reduce the total recording time.
We suggest:
1MP cameras: Set to H.264 with a 1280x720 resolution, 10fps, Bit Rate CBR of 1536kbps.
2MP cameras: Set to H.264 with a 1920x1080 resolution, 10fps, Bit Rate CBR of 2048kbps.
Important: The EXTRA STREAM MUST be enabled if you wish to remotely access the recorder.
All cameras: Set to H.264 with a CIF resolution, 10fps, Bit Rate CBR of 320kbps.
Please note that not all recorders support IP cameras, and not all recorders support 2MP
cameras.
To Begin Recording
Once you have successfully set up the cameras, exit the Menu by right clicking or pressing the CLOSE
button. By default, the system will begin recording when it is properly connected to the cameras and has
an installed HDD. If it is recording, the recording icon "
Automatic Overwriting:
When the system is in full, the oldest recorded data will be overwritten automatically. This NVR
System is set to Overwrite by factory default but can be changed in the "GENERAL" Menu.
" will be displayed on screen.
Advertisement
