Advertisement
Setting the Time and Date
When using your recorder for the first time, you will have to set the SYSTEM TIME.
Right clicking anywhere on the screen will bring up the password menu.
•
Use the mouse to enter the NVR admin password with the on-screen keypad.
Then Right click to open the menu and select "MAIN MENU".
•
Select "SETTING"
•
Select "GENERAL"
•
Set System Time, Date Format and DST (Daylight Saving Time) for your region.
•
Click Save before clicking OK
•
Important:
If you change the date or time on your system after the recording function is activated, the recorded data may
be deleted. After setting the date and time, it's recommended to clear all HDD data, and start recording again.
Network Setup
Right click to open the menu and select MAIN MENU, then select SETTINGS followed by NETWORK.
The device comes pre-configured to DHCP (which means it will automatically receive an IP
Address). If you wish to manually give it an IP Address, un-tick DHCP and then enter the IP
Address, Subnet mask, and Gateway.
4
Advertisement
