Warranty - Biasi SG 2 Manual And Installation Instructions

Page 40
FIRST YEAR-WARRANTY FOR SG SERIES RESIDENTIAL HOT WATER BOILERS: QHT warrants that its cast-iron boiler
and casing are free from defects in material and workmanship for one year from the date of installation. If the boiler is found to
be defective within this period, QHT will replace the boiler block or casing.
LIFETIME WARRANTY-WARRANTY FOR THE CAST IRON BOILER BLOCKS OF THE SG SERIES RESIDENTIAL
BOILERS: Biasi warrants that the cast-iron sections and nipples of the BIASI SG boilers are free from defects in material and
workmanship for the lifetime of the original single family home installation. If the SG boiler block is then found to be defective,
QHT and Biasi will replace the original cast iron boiler block.
These warranties are subject to the condition that a heating contractor whose principal occupation is the sale and installation of
heating equipment must have installed the boiler.
PARTS, WHICH ARE COVERED, consists of all materials supplied by Biasi, identified by QHT's part numbers in its literature.
Other parts supplied in the casing, trim kit or in the burner pack carry their own warranty and each manufacturer has
responsibility for its own products.
NOTE: ANY PART, WHICH IS REPLACED UNDER WARRANTY, CARRIES ONLY THE UNEXPIRED PORTION OF
THE ORIGINAL WARRANTY.
OWNER RESPONSIBILITIES:
1. Provide for proper installation, which includes pressure relief and pressure reducing valves and high limit safety controls on
closed systems.
2. Provide qualified periodic service to prolong proper operation and service.
3. Insure that boiler is installed with approved burner and that installation conforms to all codes and ordinances.
4. This warranty does not apply to boilers, which are subject to misuse, abuse, neglect, alteration, accident, excessive
temperature, excessive pressure, or corrosive water or atmosphere.
5. Owner will be responsible for return of faulty components to Portsmouth, NH, freight pre-paid.
QHT and Biasi will not be responsible for:
1. Components that are part of the heating system, but were not manufactured by Biasi or QHT as part of the boiler.
2. The workmanship of the installers of SG boilers. Furthermore, this warranty does not assume any liability for
unsatisfactory performance caused by improper installation.
3. Any costs for labor to remove or replace the faulty component.
4. Improper burner application or adjustments, control settings, care or maintenance.
5. Any damage associated with corrosion or leakage due to the use of "non-barrier", plastic pipe in the heating system.
*THIS WARRANTY DOES NOT EXTEND TO ANYONE EXCEPT THE FIRST PURCHASER AT RETAIL AND ONLY
WHEN THE BOILER IS IN THE ORIGINAL INSTALLATION SITE.
*IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY SHALL BE
LIMITED TO THE DURATION OF THE EXPRESSED WARRANTY. BIASI AND QHT EXPRESSLY DISCLAIM AND
EXCLUDE ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF ANY
EXPRESSED OR IMPLIED WARRANTY.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS THAT VARY
FROM STATE TO STATE.
For prompt warranty service, notify the installer, who, in turn, will notify the distributor from whom he purchased the boiler. If
this does not result in corrective action, contact Biasi through Quincy Hydronic Technologies (Address Below) with details in
support of the warranty claim. All claims must be processed through proper trade channels. Contact with Biasi directly is not
recommended for rapid claim settlement.
Item#: SG/C-REV.J
For BIASI SG Series Residential
Cast-Iron Water Boilers
Quincy Hydronic Technologies,
3560 Lafayette Rd.
Portsmouth, NH, 03801
Tel. (603) 334-6400

Warranty

Manufactured by:
BIASI S.p.A.
Verona, Italy
Biasi SG Series