Table of Contents
Advertisement
The computer is not picking up my heart rate
Make sure that the heart rate strap is fitted snuggly at the bottom of your
ribcage and that the sensors are slightly moistened.
The battery in the strap might be low, try another strap.
Try using the MODE Key (Bottom Left) for automatic pairing with the com-
puter. For Analog straps the displayed code will be 4-digits and displayed
as 0000. For ANT+ chest straps the code will be alphanumeric.
Check your distance from the computer during syncing to make sure your
12" (30cm) or closer.
Cycle through the personal data screens twice and attempt to pair again.
Which heart rate straps work with the Group Cycle Computer?
Any ANT+ compatible HR strap will work, pairing to an ANT+ strap will
prevent any heart rate "crosstalk".
Any analogue 5.3 KHz heart rate strap such as Polar
I am picking up another riders heart rate
If bikes and riders are close together while wearing analog heart rate straps, it
is possible to have heart rate "crosstalk" where the signal from another rider is
shown on an adjacent console. Using ANT+ heart rate straps will prevent this
problem. You can also try moving the bikes further apart.
The computer is not scanning between the Distance, Time and KCALs.
To use the SCAN feature, press the MODE key (bottom left) 3 times until
(SCAN) appears in the TRAINING display. This will automatically change be-
tween the 3 data measures in intervals of 3 seconds.
The computer timer is not working or is not running.
Press the Play/Pause/Up key (Upper Right), the timer may be in PAUSE mode.
What factors affect the battery life of the computer?
Excessive use of the back light will diminish battery life.
What batteries does the Computer and Flywheel Transmitter take?
The computer console requires three AAA batteries. The flywheel transmitter
requires one CR2032 lithium coin cell battery.
STAR TRAC Group Cycle Computer Installation
Installation & Instructions
26
®
HR will work.
23
Hide quick links:
Advertisement
Table of Contents
