Desa CF18PV Owner's Operating & Installation Manual page 21

INSTALLING
Continued
102653
INSTALLING LOGS (Split Oak Design Models)
Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when
installing. It is very important to install these logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place front logs (#1L and #1R) on top of the grate. Make sure the notches in the bottom
of the logs fit over the grate prongs (see Figure 22). Push back of logs flush with metal
grate bar. 18" model has only one front log.
Note:
2. Rest bottom middle log (#2) behind metal posts on front burner. Make sure the grooves in
the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The
pegs on the log must be on top (see Figure 23).
3. Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make
sure the peg on the log is on top (see Figure 24).
4. Place the top middle log (#4) on the bottom middle log (#2). Make sure the pegs of the
bottom middle log fit securely in the holes of the top middle log (see Figure 25).
Front Log (#1L)
Front Log (#1R)
Notch
Grate
Prongs
Metal Grate Bar
Figure 22 - Installing Front Logs
(#1L and #1R)
Groove
in Back
Peg
of Log
Grate
Prong
Rear
Burner
Figure 24 - Installing Rear Log (#3)
WARNING
Peg
Groove
Metal Post
Groove
Metal Post
Figure 23 - Installing Bottom
Rear Log (#3)
Hole
Peg
Groove
in Back
of Log
Grate
Prong
Figure 25 - Installing Top Log (#4)
Bottom Middle Log (#2)
Grate
Middle Log (#2)
Top Middle Log (#4)
Hole
Peg
Bottom
Middle Log
Continued
21