Installing Logs - Desa CF18PV Owner's Operating & Installation Manual

INSTALLING
Continued
20
INSTALLING LOGS (Standard Oak Design Models)
Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when
installing. It is very important to install these logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Slide rear log (#1) into place behind rear burner (see Figure 18).
2. Slide front log (#2) into place behind front burner. Make sure tabs at bottom of log are
behind front burner (see Figure 19).
3. Place crossover log (#3) into place (see Figure 20). Be sure to place back of crossover
log into notch on left side of rear log. The indentation under front right fork of cross-
over log must rest on rectangular knob of front log.
4. Place left front branch (#4) and right front branch (#5) (24" and 30" models) or front branch
(#4) (18" model) into place (see Figure 21). Make sure notches on bottom rest on grates.
5. Add lava rock around base of heater.
Figure 18 - Installing Rear Log
Crossover
Log (#3)
Figure 20 - Installing Crossover Log
WARNING
WARNING ICON G 001
Rear Log
(#1)
Tab
Figure 19 - Installing Front Log
Notches
Notches
Figure 21 - Installing Left Front
Branch and Right Front Branch
Front Log
(#2)
Left Front Branch (#4)
(24" & 30" models)
or Front Branch (#4)
(18" Model)
Right Front
Branch (#5)
102653