Maintaining & Storing Unit; Troubleshooting - Lumiscope AccuRead 1134 User Manual

Maintaining & Storing Unit
22
A. Use a dry, soft cloth to clean the unit. If desired, use a
cloth lightly dampened with tap water.
B. Do not use alcohol, benzene thinner or other harsh
chemicals to clean the device or cuff.
C. Before measuring, please wash your hands. Do not wash
or wet the arm cuff.
D. When storing this unit, keep it away from direct
sunlight, high humidity or dust.
Note: If the unit is being stored for a long period of time,
please remove the batteries before storing to avoid leaking.

Troubleshooting

Problem Check Point
Nothing is displayed Are the batteries
when the "ON/OFF" exhausted?
key is pressed.
Have the batteries
polarity been
positioned
correctly?
"Err P" shown on LCD Fails to inflate
Deflates too fast
"Err 1" shown on LCD
"Err 2" shown on LCD Movement has
occurred.
Signal interference
around BPM
"Err 3" shown on LCD Incorrect results
Note:
If correct measurement is impossible after troubleshooting, consult
store of purchase or Lumiscope repair department. (Do not disassemble
unit). In some rare cases, there may be error due to the physical condition
of the person. In such cases, please consult your physician. If the clock
doesn't show on the LCD, please adjust the clock settings.
23
Solution
Replace the
batteries with
new ones.
Re-insert the
batteries in the
correct position.
Make sure the cuff
is connected to
the unit properly.
Check air tube. If
broken, replace it.
Return for
servicing.
Keep still
when taking
measurement.
Remove
interference
source. example:
magnets & cell
phones.
Measure again