Helpful Tips; Troubleshooting - Lumiscope 1130 User Manual

Helpful Tips

Here are a few helpful tips to help you obtain more accurate readings:
• Do not measure your blood pressure immediately after consuming a large meal. To obtain
more accurate readings, please wait one hour before measuring.
• Do not smoke or drink alcohol before measuring your blood pressure.
• You should not be physically tired or exhausted while taking a measurement.
• It is important that you relax during measurement. Take 15-minute rest before a reading.
• Do not take measurements if you are under stress or under tension.
• Take your blood pressure at normal body temperature. If you are feeling cold or hot, wait a
while before taking a measurement.
• If the monitor is stored at very low temperature (near freezing), have it placed at a warm
location for at least one hour before using it.
• Wait about 5 minutes before taking the next pressure measurement.

Troubleshooting

If any abnormality should arise during use, please check the following points.
Symptom
No display when the
ON/OFF/START button is
pressed
EE mark shown on display or
the blood pressure value is
displayed excessively low
(high)
Note: If the unit still does not work, return it to your dealer. Under no circumstance should you
disassemble the unit and attempt repairs yourself.
Check Point
Have the batteries run down?
Have the batteries polarities been
positioned incorrectly?
Is the cuff placed correctly?
Did you talk or move during
measurement?
Did you shake the arm with the cuff
on?
Correction
Replace them with two new
alkaline.
Re-insert the batteries in the
correct positions.
Wrap the cuff properly so that it is
positioned correctly.
Measure it again quietly.
7