Hp Proliant Essentials Rapid Deployment Pack - HP ProLiant DL585 User Manual

Drives installed
1
2
3, 4, 5, or 6
More than 6
To change any ORCA default settings and override the auto-configuration process, press the F8 key when
prompted.
By default, the auto-configuration process configures the system for the English language. To change any
default settings in the auto-configuration process (such as the settings for language, operating system, and
primary boot controller), execute RBSU by pressing the F9 key when prompted. After the sett
selected, exit RBSU and allow the server to reboot automatically.
For more information on RBSU, see the HP ROM-Based Setup Utility User Guide
or the HP website
Boot op tions
Near the end of the boot process, the boot options screen is displayed. This screen is visible for several
seconds before
the following:
•
Access RBSU by pressing the F9 key.
•
Access the System Maintenance Menu (which enable
Inspect) by pressing the F10 key.
•
Force a PXE Ne
BIOS S erial Console
BIOS Serial Console allows you to configur
remotely through a serial connection to the server COM port. The server that you are remotely con
does not require a keyboard and mouse.
For more information about BIOS Serial Console, see the BIOS Serial Console User Guide on the
Documentation CD or the HP website
HP P roLiant Essentials Rapid Deployment Pack
The RDP software is the preferred method for rapid, high-volume server deployments. The RDP software
integrates two powerful products: Altiris Deployment Solution and the HP ProLiant Integration Module.
The intuitive graphical user interface of the Altiris Deployment Solution console provides simplified point-
and-click and drag-and-drop operations that enable you to deploy target servers, including server blades,
remotely. It enables you to perform imaging or scripting functions and maintain software images.
For more information about the RDP, refer to the HP ProLiant Essentials Rapid Deployment Pack CD or
refer to the HP website
Drives used
1
2
3, 4, 5, or 6
0
(http://www.hp.com/support/smartstart/documentation
the system attempts to boot from a supported boot device. During this time, you can do
twork boot by pressing the F12 key.
(http://www.hp.com/support/smartstart/documentatio
(http://www.hp.com/servers/rdp
RAID level
RAID 0
RAID 1
RAID 5
None
s you to launch ROM-based Diagnostics or
e the serial port to view POST error messages and run RBSU
).
ings are
on the Documentation CD
).
n ).
Software and configuration utilities 57
figuring