Intermec EasyCoder 501 XP Service Manual page 69

8.6 Label Stop Sensor,
cont.
Upper Sensor
Lower Sensor
Intermec EasyCoder 501 XP & 601 XP – Service Manual
Replacing the Sensors (EasyCoder 501 XP and 601 XP)
To remove the LSS bracket from the carriage, for example in con-
nection with cleaning or replacing a sensor, proceed as follows:
• Switch off the power, remove the power cord and remove the
cover over the electronics compartment.
• Remove the upper and lower plastic guide plates.
• Adjust the LSS to approximately center position.
• Disconnect the cables from P53 and P54 on the CPU board.
• Disengage the snap-lock, using a screwdriver from the media
compartment side, and push the outer end of the LSS bracket
upward. Then pull the bracket out from the carriage, taking care
not to damage the cables.
Note! The snap-lock is fragile.
• Remove the two #T8 Torx screws that hold the defective sensor
and replace it.
Snap-Lock
Carriage
Chapter 8 Print Unit
LSS Bracket
67