Table of Contents
Advertisement
Note: Safety strips are not required when fire-
place rests on a noncombustible surface.
Note: Install the hearth extension only as illus-
trated.
The safety strips should extend from front of
the fireplace at least 1 " and should extend to
be at least flush with the sides. In the event a
wooden support is used to elevate the fireplace
above the floor, a "Z" type safety strip should be
fabricated and used to protect the front surface
of the wood support as well as the floor beneath
the hearth extension ( Figures 8 and 9 ). The
safety strips should be tacked down to prevent
possible movement.
Note: The "Z" type safety strip is not supplied.
1
"
Figure 8
Figure 9
Step 3. Refer to fireplace drawings and specifi-
cations on pages 6 and 7 for framing dimensions
and details. Frame appliance enclosure as illus-
trated in Figures 11 through 14 on page 7.
IMPORTANT: UNDER NO CIRCUMSTANCES
CAN THE FIREPLACE TOP SPACERS ( FIGURE
10 ) BE REMOVED OR MODIFIED, NOR MAY
YOU NOTCH THE HEADER TO FIT AROUND OR
BE INSTALLED LOWER THAN THE SPACERS.
THE HEADER MAY BE IN DIRECT CONTACT
WITH THE TOP SPACERS BUT MAY NOT BE
SUPPORTED BY THEM.
6
FIREPLACE SPECIFICATIONS
Metal Safety Strips
Gas Line
Access
Blocking
Metal Safety Strips
Figure 10
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
7
"
(181 mm)
25"
(635 mm)
Fireplace Top Spacer
39
(1013 mm)
26
"
(676 mm)
Left Side
9
"
(244 mm)
Fireplace
Top Spacer
1"
(25 mm)
51
(1308 mm)
15"
(381 mm)
41
"
(1048 mm)
4
"
105 mm)
49
"
(1257 mm)
Front
7
(190 mm)
Combustion
Air Inlet
"
22
"
(575 mm)
26
(664 mm)
Right Side
31
"
(800 mm)
49
"
(1257 mm)
"
Top View
20"
(508 mm)
52
"
(1340 mm)
7
"
(197 mm)
"
52
"
(1340 mm)
Gas Line
Access
16
"
(413 mm)
9
"
(248 mm)
"
26
"
(676 mm)
Advertisement
Table of Contents
