Fireplace And Framing Specifications - Lennox ADAGIO-MN Installation Instructions Manual

FIREPLACE AND FRAMING SPECIFICATIONS

Framing Dimensions - All Models
in. 22-1/8
mm 562
* D shown here is not dimensioned to the vertical center of
the horizontal framing. This is to allow for the required 4"
clearance above the vent and the 1" required clearance
below the vent. This does not include the suggested 1/4"
rise per foot for horizontal runs.
** With the facade installed (required - sold separately), the
appliance base will need to be elevated a minimum of 3/4"
above the floor to allow for the proper fit of the facade (i.e.
use 3/4" board minimum as platform).
Adagio
f i r e - p a r t s . c o m
Natural Gas
Propane Gas
Notes
Diagrams, illustrations and photo-
graphs are not to scale – consult
installation instructions. Product
designs, materials, dimensions,
specifications, colors and prices are
subject to change or discontinuance
without notice.
Figure 12
10
Inches (millimeters)
A B C
40-1/4 15-3/4 44-1/8
1022 400 1121
Efficiencies %
BTU/hr Steady EnerGuide
State P4
10,000-13,000 71.82% 58.3%
10,000-13,000 73.27% 59.4%
15-1/32
15-15/32
(393)
40-1/32
(1017)
34
(864)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
D
Framing should be
constructed of 2x4
or larger lumber
B
Co-axial DV Vent
4-1/2" (114) Inner
7-1/2" (191) Outer
(382)
14-3/4 (375)
21-1/16 (535)
Framing With Platform
10¹⁄₂
( )
267
VENT FRAMING -
TOP VENT WITH ONE
90° ELBOW
D
Platform
C
A
The platform should extend the full width
and depth of the fireplace base.
7-11/16
(195)
20-3/4
(527)
1-7/8
(48)
5-13/32
(137)
6-1/16
(154)
8-7/32
(209)
36-23/32
(933)
1-1/2
(38)