Power Supply; Inserting Batteries; Charging Batteries - Sony DWZ-M70 Operating Instructions Manual

Power Supply

This section describes the power supply for each device.
For details on how to insert batteries, see "Inserting
Batteries" (page 9).
Handheld microphone (ZTX-M02RC),
body-pack transmitter (ZTX-B02RC)
Power supplied by two LR6 (size AA) batteries.
The following types of battery can be used.
• Alkaline dry cell batteries
• Rechargeable nickel-metal hydride batteries
• Lithium batteries
Half-rack receiver (ZRX-HR70)
Power supplied by the supplied AC adapter.

Inserting Batteries

CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.
Notes
• Always use sets of the same type of battery. Do not use
batteries of different types or remaining charges
together as a set.
• Replacing the batteries during operation will result in
high noise. Be sure to turn off the unit before replacing
the batteries.
Handheld microphone (ZTX-M02RC)
1
Slide the POWER switch to turn off the unit.
2
Turn the grip in the direction of the arrow, and pull
down the grip until the battery compartment is shown.
3
Insert two new LR6 (size AA) batteries while making
sure the polarities are correct.
4
Close the grip and turn it in the reverse direction in
the step 2 above.
Body-pack transmitter (ZTX-B02RC)
1
Press and hold the POWER/MUTING button to turn
off the unit.
2
Slide the battery-compartment catches inward (in the
direction of the arrows b B) to take out the
compartment.
3
Insert two new LR6 (size AA) batteries into the
battery compartment while making sure the polarities
are correct, and then reinsert the compartment into the
unit.
Make sure that the battery compartment is locked
securely inside the unit.

Charging Batteries

You can recharge batteries by inserting rechargeable
nickel-metal hydride batteries into the transmitter and
using the dedicated BC-DWZ1 battery charger (not
supplied).
We recommend using Sony nickel-metal hydride
batteries (2000 mAh or more).
Note
Before charging the batteries, check the remaining charge
of the transmitter's batteries in the receiver's display.
9
Power Supply