Transmitter Settings; Configuring The Transmitting Channel Settings - Sony DWZ-M70 Operating Instructions Manual

3
Select the connectors for which you want the muting
function enabled.
Screen display
Connector
BALANCED OUTPUT
UNBALANCED
OUTPUT MAIN
UNBALANCED
OUTPUT AUX/
TUNER
This completes the configuration, and the main
screen appears again.
Configuring the battery type
Specify the type of battery that is being used in the
transmitter so that the transmitter's remaining battery
charge can be displayed properly on this unit. The factory
default setting is [Alkaline].
1
In the [Setup] screen, select [Advanced Settings].
2
Select [Battery Type].
3
Select the battery type.
Alkaline: Alkaline dry cell batteries are being used in
the transmitter.
Ni-MH: Rechargeable nickel-metal hydride batteries
are being used in the transmitter.
Lithium: Lithium batteries are being used in the
transmitter.
This completes the configuration, and the main
screen appears again.
14

Transmitter Settings

To
To All To AUX/
Balanced
Outputs Tuner
& Main
Only
Only
–
Enabled
–
Enabled
– Enabled
Transmitter Settings
Configuring the Transmitting
Channel Settings
Two RF modes (channel modes), [Wide Band] and
[Narrow Band], are available on the DWZ.
Each RF mode consists of six channels. Select the
appropriate channel according to your intended use. The
RF mode is set to [Wide Band] and the transmission
channel is set to 1 under factory default settings.
RF mode Transmitting
channel number
Wide Band 1/2/3/4/5/6
(WIDE)
Narrow Band a/b/c/d/e/f
(NARROW)
Caution
When using multiple channels (up to six), the two RF
modes, [Wide Band] and [Narrow Band], cannot be used
simultaneously. Select only one RF mode during use. In
addition, Wi-Fi and other environmental interference may
reduce the actual number of channels that can be used
simultaneously.
Selecting the RF mode
1
Turn off the unit.
To turn off the ZTX-M02RC, slide the POWER
switch to the OFF position.
To turn off the ZTX-B02RC, press and hold the
POWER/MUTING button.
2
For the ZTX-M02RC, slide the POWER switch to the
ON position while holding down the channel
selection button.
For the ZTX-B02RC, press and hold the POWER/
MUTING button (about 1 second) while holding
down the channel selection button.
"0" blinks in the channel display.
3
Press the channel selection button to select "1" or "a."
4
Press and hold the channel selection button.
Description
This mode reduces any
interference to other
wireless equipment.
This mode uses the Clear
Channel Scan function,
making it useful for
avoiding any interference
from other wireless
equipment.