Remote Control - Insignia NS-32D220NA16 User Manual

NS-32D220NA16 Insignia 32" 720p 60Hz LED TV
Problem Solution
Good picture, but
• Increase the volume.
no sound.
• Make sure that the sound is not
• Make sure that you do not have
• Press AUDIO to change to a
• If you are using a home theater
• If you are using a home theater
• If you are using a home theater
• Make sure that the audio cables
• Make sure that the antenna or
• If you are using an antenna, the
• The audio cables you are using
Poor picture.
• Make sure that the room is not
• If an S-VHS camera or a
muted.
headphones connected. When
headphones are connected, no
sound comes from the TV
speakers.
different audio mode.
system, sound bar, or external
speaker system, make sure it is
turn on and is not muted.
system, sound bar, or external
speaker system, make sure that
you have selected the correct
output mode.
system, sound bar, or external
speaker system and have
connected it with a digital
optical cable, go to the Audio
menu, highlight Digital Audio
Format/Audio Delay, then
press ENTER. Set the Audio
Format option to PCM. See the
Digital Audio Format/Audio
Delay option in "Adjusting
sound settings" on page 45.
are connected correctly and
securely to your TV.
cable TV is connected correctly
and securely. See "Connecting a
cable or satellite box" on
page 13 or "Connecting an
antenna or cable TV (no box)"
on page 17.
digital channel signal may be
low. To check the digital
channel signal strength, see
"Checking the digital signal
strength" on page 50.
may be bad. Try a new set.
too bright. Light reflecting off
the screen can make the picture
difficult to see.
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
www.insigniaproducts.com
Problem Solution
Good sound, but
• Adjust the contrast, color, and
poor color.
Audio noise.
• Other devices (for example, a
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote
• Make sure that the power adapter is
control does
plugged into a working outlet.
not work.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see
remote
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control
page 31.
• Replace dead batteries with new
batteries. See
control
brightness settings. See
"Adjusting the TV picture" on
page 43.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
"Adjusting sound settings" on
page 45.
are connected correctly and
securely to your TV.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
"Aiming the
control" on page 31.
"Installing
batteries" on
"Installing remote
batteries" on page 31.
65