Assembly; Operations; Charging; Control Buttons - Bissell BOLT ION 1311 SERIES User Manual

Asse mbly
No tools are required for assembly; simply insert
foot into body of unit until you hear a click.

Charging

1. Insert the charging adapter plug into the
charging port on the back of the unit or the
bottom of the charging base.
2. Plug the adapter into the wall outlet. If using
the charging base, place unit onto base. The
power LED lights will illuminate when charging.
Charge the unit completely for 4 hours prior to
first use.
NOTE: The adapter may become warm during
charging – this is normal. The unit can remain
plugged in even when the charge is complete.
3. When the unit is fully discharged,
approximately 4 hours of charging is required
for the battery to regain full capacity.
Battery Status LED Color
100% Blue
66-99% Blue
33-65% Blue
10-32% Blue
0-9% Red
Operation s

Control buttons

The power button is located on the top
of the handle. Settings include:
a. Power Icon = On/Off
b. Brush Icon = Brush On/Off
c. Suction Icon = Normal/High
d. EdgeReach = On/Off
Using your cordless vacuum
1. Push power button ON.
2. Push brush button on to easily clean
hard floors, low pile carpet, and area rugs.
3. Use suction button to control power
of suction.
Charging
Light Behavior
3 solid lights for 10 min.,
then fl ashes once per minute
2 lights on, 1 light blinking
1 light on, 1 light blinking
1 light blinking
1 light blinking quickly
WARNING
Do not plug in your vacuum cleaner until
you are familiar with all instructions and
operating procedures.
1.
a. b.
c. d.
www.BISSELL.ca
5