Section C; Installation; Selecting A Location; Tools Needed For Installation - Toyotomi Oil Miser OM-148 Installation Manual

SECTION C:

INSTALLATION

WARNING: This unit must be installed in accordance with these instructions, local codes, ordinances and/or
in the absence of local codes, the latest edition of the national fire protection association
(NFPA31) code.
Check and comply with all state, local codes and ANSI (AMERICAN NATIONAL STANDARD
INSTITUTE) Z21.22 that may apply to water heater(s) before beginning the installation.
This unit should be installed by a licensed, authorized person(s) due to the necessity of making
electrical, water and fuel connections.
CAUTION: When No. 2 fuel oil is used in an area where the temperature becomes less than 25˚F (-4˚C), it is
recommended the use of an additive with the fuel to prevent congealing. Check with a fuel supply
company for the proper additive and mix.
Select a place to install the water heater where water and electric supply are easily available.
1. Select a place which is free of moisture, water spills, pools or snow.
2. Select a place which draining can be done easily.
3. Select a place which the fuel tank can be installed safely.
4. Select a place which is free of combustible substances.
5. The surrounding walls should be finished with noncombustible materials (concrete block, mortar, or
plaster are allowable).
6. The floor on which the water heater is installed must prevent intensive vibrations or shock and must be
strong enough to bear the weight of the water heater.
7. Select a place where proper maintenance and control can be provided for the unit after installation.
8. Select a place sheltered from weather.
9. Install the unit on a noncombustible surface in a stable position. If installing on combustible floor, the
unit should be raised off the floor to prevent contact with combustible materials.
10. It is important to keep enough clearance for the purpose of maintenance, repair and possible servicing.
11. The flue pipe is free of snow, icing, leaves, bird's nest or strong drafts.
12. Before making a hole in your wall for the flue pipe, make sure the area is free of electrical wires, gas
pipes and other obstacles.
Tool
Phillips Head Screwdriver
Electric Drill
Hole Saw, 4-3/4" diameter
Pipe Wrench

SELECTING A LOCATION

TOOLS NEEDED FOR INSTALLATION

Use
Installation of flue pipe, etc.
Drilling hole in wall for flue pipe
Making hole in wall for flue pipe
Connecting fuel pipe
.
4