Service - Troy-Bilt TB-38 Operator's Manual

Service

Cutting Deck Removal
To remove the cutting deck, proceed as follows:
1. Place the PTO (Blade Engage) lever in the disengaged (OFF)
position and engage the parking brake.
2. Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
3. Remove the belt-keeper rod, from around the tractor's
engine pulley, by removing the self-tapping screw (A) that
secures it. See Figure 7-1.
NOTE: Make a mental note what hole the other end of the belt-
keeper rod is inserted in for reinstallation purposes.
C
4. Remove the belt (C) from around the tractor's engine
pulley and idler pulley(s). See Figure 7-1.
5. Looking at the cutting deck from the left side of the tractor,
locate the bow-tie pin that secures the deck support rod
on the rear left side of the deck. See Figure 7-2. Remove
the bow-tie pin that secures the deck support rod, and
carefully remove the deck support from the deck lift arm.
6. Repeat the above steps on the tractor's right side.
22
A
B
Figure 7-1
Figure 7-2
7. Move the deck lift lever into the top notch on the right
fender to raise the deck lift arms up and out of the way.
8. Gently slide the cutting deck toward the front of the tractor
carefully guiding the hooks on the deck off of the deck
stabilizer rod. See Figure 7-3.
Figure 7-3
7