NETGEAR WNR1000v2 Setup Manual page 28

– Then, enter this PIN in the Enter Client's PIN field provided on the router and click
Next. You have 4 minutes to enable WPS on the router using this method.
Figure 16
Using either method, the client wireless device will attempt to detect the WPS signal from the
router and establish a wireless connection in the time allotted.
• If no connection is detected:
– WPS did not establish a secure connection with a wireless device.
– Neither the SSID nor the WPA/WPA2 security settings were configured on the router.
• If a connection is established:
– The router WPS screen displays a message confirming that the wireless client was
successfully added to your wireless network.
– The router generated an SSID, implemented WPA/WPA2 wireless security (including
a PSK security password), and broadcast these settings to the client; the client now
shares the same security settings as the router.
If the router was already configured manually, and either WPS/PSK or
WPA2/PSK security enabled and a PSK security password selected, then
the client now shares these same security settings.
Note your SSID and WPA/WPA2 PSK security password (whether previously set or
4.
generated) for your wireless network.
Configuring Your Wireless Network 24