NETGEAR WNR1000v2 Setup Manual page 18

Connect any additional wired PCs to your router by inserting an Ethernet cable from a PC into
7.
one of the three remaining LAN ports.
Review that your network is now set up (as shown in
8.
network.
Figure 9
9. Start your network in the correct sequence, as described below.
Failure to start or restart your network in the correct sequence could prevent you
from accessing the Internet.
To start your network:
Plug in and turn on the cable or DSL modem. Wait 2 minutes.
1.
Plug the end of the power adapter's cord into the wall or a power strip, and into the power
2.
adapter outlet of your wireless router (F), as shown in
Figure 10
Manually Installing Your Router
F
Figure 9); you are ready to start your
Figure 10. Wait 1 minute.
14