Using The Custom Code Override; Eliminating The Normal Arm/Disarm Chirps; Remote Panic Operation - Prestige APS-510E Owner's Manual

MANUALLY OVERRIDING YOUR SYSTEM

USING THE CUSTOM CODE OVERRIDE

Assuming the override code programmed has not been changed, and the default
override code of 11 is in the system's memory.
1. Enter the vehicle and turn the ignition switch to the on position.
NOTE: The siren will sound.
2. Within 5 seconds, press and release the PBLED switch 1 time.
3. Within 5 seconds, turn the ignition switch off then on.
4. Within 5 seconds, press and release the PBLED switch 1 time.
5. Turn the ignition switch off then on and start the vehicle.
NOTE: If you have changed the programmed override code then substitute your
new code tenths for step 2 above, and units for step 5 above.

ELIMINATING THE NORMAL ARM/DISARM CHIRPS

You can selectively eliminate the normal arm & disarm chirps by holding the transmitter
button slightly longer when arming or disarming.
This will prevent the siren chirps for one arm or disarm cycle.
If you find this inconvenient and wish to eliminate these chirps permanently:
1. Turn the ignition switch 'on" then 'off".
2. Within 10 seconds of turning off the ignition, press and release the Push Button
LED switch 3 times.
3. If the chirps were on before you started, the siren will emit 2 short chirps indicating
that the chirps are now off. If the chirps were off before you started, the siren will
emit one short chirp indicating that the chirps are now on.
NOTE: If the vehicle battery is disconnected then reconnected, the unit will return
to the default setting of chirps on. Repeat the above procedure to eliminate
the arm/disarm chirps.

REMOTE PANIC OPERATION

The ARM or DISARM button on your keychain transmitter also functions as a panic
switch for use in emergency situations. To use remote panic:
Page 10
128-9313
10 of 16