Disarming The System; Intrusion Warning Signals; Valet System Override Switch - Prestige 128-4243B Owner's Manual

3. Whenever the system is triggered, the vehicle's parking lights will flash for the 60 second
alarm cycle, attracting added visual attention to the vehicle.
4. Whenever the system is armed, the vehicle's starter will be bypassed. If a thief should
choose to ignore the siren, the vehicle can not be started.
DISARMING THE SYSTEM (CHANNEL 1) :
1. As you approach the vehicle, press and release the ARMING button on the keychain
transmitter.
WARNING! Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
2. The siren will "chirp" 2 times, the vehicle's parking lamps will flash two times and the
doors will unlock indicating the system is DISARMED.
3A. ACTIVE : The dash mounted L.E.D. will turn off, and remain off until the system is re-
armed.
3B. PASSIVE : Never attempt to disarm the system from a distance that prevents you from
opening a door within 30 seconds. Since the system is programmed for pasive arming,
it will begin to re-arm until a door is opened. Opening the door will suspend the passive
arming cycle.

INTRUSION WARNING SIGNALS:

The system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when

disarming the system.

The vehicle's parking lights will also flash 3 times to indicate an intrusion has occurred. Enter
the vehicle and observe the dash mounted L.E.D. for further information.
1. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion attempt
was made to the hood, trunk, or an optional sensor.
2. If the L.E.D. is flashing three times...pause...three times...etc., then an intrusion attempt
was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory, and will only be erased
from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the
need to hand your transmitter to parking attendants or garage mechanics. When the system
is in valet mode, all alarm functions are bypassed, however, the remote panic feature and
remote door locks will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
Page 3
128-4243B
4 of 20