Before Requesting Help
Cordless Telephone
Problem
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or the base
unit do not ring.
The handset display is
blank.
The handset display is still
blank after pressing
(‹)
BACK (fi)
,
or
(fl)
.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
88
Cause and Remedy
≥You are too far from the base unit.
Move closer and try again.
≥Place the handset on the base unit and
try again.
≥Plug in the AC adaptor.
≥Raise the base unit antenna.
≥Locate the handset and the base unit
away from other electrical appliances
(p. 3).
≥Move closer to the base unit.
≥Raise the base unit antenna.
(FUNCTION/EXIT/CH)
≥Press
clearer channel.
≥The ringer volume is set to OFF. Set to
HIGH or LOW (p. 22).
≥If the line is connected to a low voltage
system such as a PBX, the unit may not
ring. Set the line mode to "B" (p. 19).
≥The handset is in the standby mode
(p. 16). Press
FWD/EDIT (fl)
≥Charge the battery fully (p. 15).
(›)
,
FWD/EDIT
≥You cannot store an item in the
directory while the unit is in the talk,
speakerphone or intercom mode, or
while the answering system is in use.
≥Do not pause for over 60 seconds while
storing.
≥To answer the call, press
(DIGITAL\SP-PHONE)
the beginning after hanging up.
to select a
(›)
(‹)
BACK (fi)
,
,
or
to turn the display on.
(TALK)
or
. Start again from