Table of Contents
Advertisement
If you have installed a modem, use the cable provided with the
modem to plug into the mainboard WOM1 connector. This enables
the Wake On Modem (WOM1) feature.
When your system is in a power-saving mode, any modem signal
automatically resumes the system. You must enable this item using
the Power Management page of the Setup Utility. See Chapter 3
for more information.
Pin
Signal
1
5VSB
2
GND
3
-RING
CD1/2:CD-ROM/DVD Audio Input Connector
If you have installed a CD-ROM drive or DVD-ROM drive, you
can connect the drive audio cable to the onboard sound system.
On the mainboard, locate the two 4-pin connectors CD1 and CD2.
There are two kinds of connector because different brands of CD-
ROM drive have different kinds of audio cable connectors.
Connect the cable to the appropriate connector.
CD1
Pin
Signal
1
CD IN L
2
GND
3
GND
4
CD IN R
CD2
Pin
Signal
1
GND
2
CD IN R
3
GND
4
CD IN L
2: Mainboard Installation
21
Advertisement
Table of Contents
