Radio Shack 60-2797 User Manual

Brum Preschool
RC Car
60-2797
Step One
Installing Batteries
You will need...
Four AA batteries for the car
One 9V battery for the transmitter
Put AA Batteries in the Car
• Slide ON/OFF switch at the bottom of
your Brum to OFF.
• Insert a coin into the slot
on the battery cover and
slide the cover back until
it clicks. Lift open the
cover.
• Install four AA batteries
and match + and - signs
with the product.
• Close the cover and slide
it forward until it clicks.
Do not try to remove hinged battery
compartment cover.
Put 9V Battery in Transmitter
• Slide the battery com-
partment cover, located
on the bottom, in the
direction of the arrow
and remove it.
• Insert one 9V battery
and match the + and -
signs with the product.
• Replace the battery cover.
Step Two
Driving the Brum
• Slide the ON/OFF switch at the bottom of
your Brum to ON. The Brum sounds its
engine, honks its horn, rocks its body and
greets you by rotating its starter handle.
• Use the transmitter's control levers to con-
trol the Brum's movement and direction.
Left Control Lever
• Push the left control lever forward to move
forward. The Brum honks its horn and
sounds its engine.
• Pull the lever backward to move backward. The
Brum sounds its engine.
• Release the lever to stop the Brum with tire squeal
sound.
Right Control Lever
• Push the lever left to turn left, and right to turn right. The Brum leans
left and right as it changes directions.
• Release the lever to go straight.
Turn the ON/OFF switch to OFF when you finish driving the Brum.
What's Included
Brum Preschool RC Car
Transmitter
Rear View of Brum
Hood
Spare Wheel
Left
Forward
Backward Right
Brum on the Go
Eyes rotate and starter handle twirls when moving forward.
Owner's Manual
Steering Wheel
Driver's
Seat
Number Plate
Eyes
(Headlamps)
Starter Handle