Stihl FS 70 Instruction Manual page 20

English
Mounting the Barrier Bar
1
1
2
2
5
5
3
3
Take out the screws (1) and remove
N
along with washers (2) and nuts (3).
Remove the loop handle (4) and
N
clamps (5).
3
Fit the square nuts (3) in the barrier
N
bar (6); the holes must line up.
18
4
4
8
9
1
Place the clamp (7) in the loop
N
handle (4) and position them both
against the drive tube (8).
Position the clamp (8) against the
N
drive tube.
Place the barrier bar (6) in position
N
as shown.
Line up the holes.
N
Insert the screws (1) in the holes
N
and screw them into the barrier bar
as far as stop.
3
Go to "Adjusting and Securing the
N
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
6
7
1
Adjusting and Securing the Loop Handle
A
4
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 15 cm (5.9 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
FS 70 R