Janome MB-4S Instruction Book page 75

¤4
SET8
Jump Thread Trimming
Number of Jumps
3
Minimum jump thread length to cut
¤5
SET8
Jump Thread Trimming
Number of Jumps
3
Minimum jump thread length to cut
¤6
SET8
Jump Thread Trimming
Number of Jumps
3
Minimum jump thread length to cut
¤4 Jump thread trimming ON/OFF
q
If you wish to trim jump threads automatically, press
the circle key next to "ON".
A check mark will appear in the box.
Press the circle key next to "OFF" to disable the jump
thread trimming.
q Circle keys (ON, OFF)
¤5 Jump thread trimming threshold
If you insert jump codes when creating a custom
q
design embroidery pattern using a digitizing software,
you can adjust the position of jump thread trimming by
setting the number of jump codes.
The machine will trim the jump thread automatically
after the specified number of jump codes.
Press the circle key next to "+" or "–" to adjust the
number of jumps.
q Circle keys (+, –)
The default setting is 3 and adjustable range is from 1
to 8.
NOTE:
Turn off the setting ¤6 below, when using this function.
¤6 Jump thread trimming threshold (length)
If you do not have a digitizing software, you can adjust
q
jump thread trimming by length.
Press the circle key next to "+" or "–" to set the
minimum length of jump thread to cut .
The machine will automatically cut jump threads
longer than the length selected.
q Circle keys (+, –)
To turn this function off, press the circle key next to "+"
until "OFF" is indicated.
The adjustable range is from 1 mm to 30 mm.
NOTE:
Set the jump code number to 8 when using this
function.
Press the OK key to register the new settings.
Or press the next page key to go to the next page.
73