Oki ES9465 MFP Troubleshooting Manual page 35

1.TROUBLESHOOTING FOR THE HARDWARE
4
Raise the lever and open the upper stacker of the
finisher.
5
Open the cover of the Hole Punch Unit when it is
installed.
6
Turn the knob shown in the following figures to send the paper, and then remove the
misfed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
When the Hole Punch Unit is not installed
Some misfed paper may get inside of the Saddle Stitch unit depending on the location where the misfeeding
occurs. In this case, follow step 7.
7
Close the upper stacker of the finisher.
Place your hands on the near and far side of the lever and push to
close the tray until it clicks.
Be careful not to let your fingers be caught between the
finisher body and the stacker (Upper) of the finisher.
This could injure you.
1 TROUBLESHOOTING FOR THE HARDWARE
2
When the Hole Punch Unit is installed
Clearing a Paper Misfeed
1
33