Emptying The Dirt Container - Bissell 1617 SERIES TOTAL FLOORS User Manual

Operations
On-board Tools
Your vacuum is not only a powerful carpet
and rug cleaner; it is also a versatile above floor
vacuum cleaner when you select one of the
special tools.
1. Raise the handle to the upright position.
2. Remove the hose wand from the hose wand
base. This automatically diverts the suction to
the hose.
3. Use the hose alone or attach any tool by firm-
ly pushing onto the vacuum hose, hose wand, or
extension wand. They are a friction fit, so be sure
the hose and tool fit snuggly together
Dusting brush/upholstery tool:
Two types of cleaning tools are included in one
attachment. Slide the tool out to use with or
without bristles and switch between the
two uses.
a. Use the dusting brush to dust furniture,
blinds, books, lamps, shelves and
baseboards.
b. Slide the brush off to use the upholstery
tool on cushions, draperies and fabrics.
TurboBrush Tool (select models):
Use rotating brush action for small flat areas
such as stair and cushions. Press gently down
and pull toward you in raking motion; too much
pressure will cause brush to stop rotating.

Emptying the dirt container

Empty the dirt container as soon as the dirt
reaches the "fill" line on the front of the cup.
1. Unplug the vacuum from the electrical outlet.
2. Slide the Lock 'n Seal lever to the left.
3. Grasp the handle and pull the dirt cup straight
out to remove from the vacuum.
4. Empty dirt into garbage container.
NOTE: Emptying the dirt container after every
use will help prevent overfilling, and ensure
that the vacuum is ready to go the next time
you clean.
www.BISSELL.com
8
CAUTION
Always place the vacuum cleaner on the floor in its fully
upright position and make sure it is locked in place when
using tools. It is recommended to turn off the brush roll
when using tools.
NOTICE
While vacuuming, certain carpets and low humidity
conditions may generate small static discharges. The
discharges are entirely harmless and are not associated
in any way with the main power supply.
» It is recommended to turn
2.
Tip
off the brush roll when the
hose is removed and you are
using the on-board tools