Connecting Speaker Cables - Yamaha RX-V500D Owner's Manual

1 2 3 4 5 6 7 8 9 10
Speaker connections
■

Connecting speaker cables

Speaker cables have two wires. One is for connecting the negative (-) terminal of the
unit and the speaker, and the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to the negative and the other wire
to the positive terminal.
a Remove approximately 10 mm (3/8") of insulation from the ends of the speaker cable and
twist the bare wires of the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
d Tighten the terminal.
c
+ (red) F R
b
O N
T
a a
d
- (black)
Using a banana plug
(Australia model only)
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
a
F R
O N
T
Banana plug
b
■
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
Audio pin cable
PREPARATIONS ➤ Connecting speakers
15
En