•
The engine maintenance mode is activated when the power is turned ON while keeping the FORM
FEED key and ENTER key pressed down.
•
This mode adopts the menu for function selection.
•
The method for exit from this mode depends on the setting.
•
The engine maintenance mode provides the following functions:
(1) Head Drive Time Setting
•
Sets the drive time of the LED head.
(2) 600 x 1200 DPI strobe time
•
Do not change the default setting.
(3) Printing Start Position Setting
•
Sets the printing start position.
(4) Drum Count Total Display
•
Displays on the LCD the total number of drum revolutions of the unit, counted at the engine
block.
(5) Drum Count Display
•
Displays on the LCD the total number of EP drum revolutions counted at the engine block.
(6) Factory Adjustment (for High Capacity Second Paper Feeder/Power Envelope Feeder)
•
Do not change the default settings since these are factory settings and were set at the factory.
(7) Engine Reset
•
No items subjected to, All except counters are subjected to reset, As a common spec.
(See Table 4-1)
41356901TH Rev.2
153 /