Finishing; Glass Door Installation And Removal; Log Placement - Napoleon Vittoria GD19N Installation And Operation Instructions Manual

24
Before the glass door can be removed, the optional front must be removed. The glass door is secured to the top front edge
of the fi rebox and retained by the bottom.
1. Unlatch door
2. Pull handle and rotate 90°.
3. Pivot door slightly and lift out of bottom retainer.
In order to assemble the log set, the glass door must be
removed, see Glass Door Removal.
FIGURE 59a-d
1. Place the rear log as shown, ensuring the holes on the
underside are placed onto the 2 pins of the log support.
2. Place the left log as shown, ensuring the hole on the
underside is placed onto the burner pin. This will rest on the
left side of the rear log.
W415-0612 / A / 11.05.07

FINISHING

GLASS DOOR INSTALLATION AND REMOVAL

LOG PLACEMENT

BRACKET
FIGURE 58
3. Place the center log as shown, ensuring the holes on the
underside are placed onto the two center pins.
4. Place the hole in the underside of the right log onto the
locating pin, on the burner base and rests against the rear
log as shown.
5. Re-install the glass door.
90°